How to connect a VCR?

Some people still have cassettesin VHS formats, and they are not going to part with their archive. However, their safety is low enough. But there is an option to save information recorded on videotapes. You can digitize it, only for this you need to know how to connect the VCR to the computer. Moreover, it is not difficult, but you will have to spend money on a TV tuner.

We get a TV tuner

To connect a VCR to a PC,you will need to purchase a video editing card or a TV tuner. It is worth noting that the cheapest devices cost less than $ 50, but to get a better picture it's better to buy a TV tuner with hardware encoding of the stream in MPEG2. Also, when purchasing, make sure that the tuner or video board is equipped with a composite or component input, or even better, with S-Video.

Connect the VCR to the computer

First of all, you need to connect a cable fromoutput connector of the VCR to the input connector of the video editing card or the tuner. Then connect the cable from the VCR's audio signal to the input of the sound card. For which you will need to purchase an adapter RCA-minijack in advance. After that, you will need to install the video editing program, VirtualDub is suitable for these purposes. Then you should set the tuner as the input video signal, and as the sound signal - the sound card input. Now we expose the parameters of video encoding and save movies in digital format.

Connect the VCR to the TV

If you do not want to bother with digitizing, andYou want to watch the tapes, then you can connect the VCR to the TV. And it can be done via AV-out or use high-frequency output. However, before connecting the VCR to the TV, make sure that both have AV jacks. It will also be necessary to take care of the presence of a cable through which the devices will transmit the video stream over the communication channel in AV mode. To connect the VIDEO and TV on the AV channel, only one cable will be required, at both ends of which there must be corresponding outputs. It is also recommended to disconnect the antenna output so that there is no interference from its side. Speaking of how to connect a video to the TV, you need to mention the transmission of sound. After all, some models do not support the transfer of stereo sound, which should be taken into account when setting up the display on the TV. If the VCR reproduces only mono sound, then only one speaker can work on the TV, which should also be switched to mono mode. Now you know how to connect a VCR to a PC and a TV and will enjoy rare materials.



Related news

How to connect a VCR How to connect a VCR How to connect a VCR How to connect a VCR How to connect a VCR How to connect a VCR How to connect a VCR How to connect a VCR How to connect a VCR How to connect a VCR